Page 1 of 1
can't set basic table
Posted: Mon Aug 15, 2011 1:52 am
by nnffssaa
since i update firmware from 2.6 to 2.891(MS II V3.57)
can't set the basic table
what's the problem with that?
and thanks for reply
MS new guy
i use sym RV 180 engine(motorcycle engine 171 c.c) with bosch 0 277 100 124 ignition control
Re: can't set basic table
Posted: Mon Aug 15, 2011 4:36 am
by Matt Cramer
Is your MSQ set up for using a MAF?
It might help if you posted a whole copy of the MSQ - that would give more info on what settings might be locking you out.
Re: can't set basic table
Posted: Mon Aug 15, 2011 6:54 pm
by nnffssaa
Matt Cramer wrote:Is your MSQ set up for using a MAF?
It might help if you posted a whole copy of the MSQ - that would give more info on what settings might be locking you out.
thx for your reply
when i saw your suggestion, now i find out the problem.
that i select map only. when i selection adjust map for bar,the spark and ve table is able to use.
and sorry to you ,because i forget to view the 2.8 manual
i just reviewed the older manual
SRY and thanks for your reply
Re: can't set basic table
Posted: Mon Aug 15, 2011 8:16 pm
by nnffssaa
but i have some question
when i cranking the engine,the wue always on off .But i set that 100
Re: can't set basic table
Posted: Tue Aug 16, 2011 1:11 am
by nnffssaa
this is my MSQ
Re: can't set basic table
Posted: Tue Aug 16, 2011 4:35 am
by Matt Cramer
nnffssaa wrote:but i have some question
when i cranking the engine,the wue always on off .But i set that 100
Well, yes... 100% WUE means the WUE is off.
Re: can't set basic table
Posted: Tue Aug 16, 2011 5:17 am
by nnffssaa
Matt Cramer wrote:nnffssaa wrote:but i have some question
when i cranking the engine,the wue always on off .But i set that 100
Well, yes... 100% WUE means the WUE is off.
but when i cranking engine WUE indicator always flicker,and engine difficult to start.