MSefi.com read only forum (Jan.15,2018)

I purchased a blue MS-II daughter board in 2007 and couldn't get it to work thinking it was a problem with the trigger signal for the EDIS. It turned out to be dirty connectors in the EDIS system, but I had already re-installed the MS-1 processor with the pin bent up. I'm back trying to get the MS-II working for the idle control(can't stop the air from getting in through the throttle body IAC port). I know now the ignition on the car side works and I'm using tuner studio lite and have ver. 2.886 firmware. I believe all the settings are correct and I'm running into the same problem, my question is, will the MS-II work on the V1.01 board? -pj

It'll work on the V1.01 boards; it's just some of the extra outputs allowed by the MS2 are harder to install.

That helps alot, do you know of a help or manual page or forum that address the V1.01 mods?

The schematics are a bit hard to find, but they're located here:

http://www.bgsoflex.com/v1/v1.html

No real mods guide, although you can use the V2.2 mods as a starting point.