AEM UEGO Issue

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
turbo83
MegaSquirt Newbie
Posts: 3
Joined: Sun Nov 27, 2011 11:01 am

AEM UEGO Issue

Post by turbo83 »

In just I few week I will buy a MS2 v3.57 I downloaded the TunerStuido software and I am getting familiar with this software and on the first setup on the choosing the type of the wideband I noticed that it only have the AEM UEGO Linear 30-42xx and the AEM UEGO (legacy) controller 30-230x but there not the option for the AEM UEGO 30-4100 that I already have the AEM UEGO 30-4100 wideband sensor install on my car I make a search of this issue I found users have problem on the reading that its not accurate, want to check if this issue was resolve on doing some adjustment or modd on the MS or on the tunning software

Thanks!
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: AEM UEGO Issue

Post by Matt Cramer »

42xx and 41xx controllers have the same calibration curve, at least according to AEM's published specs.
Top
Post Reply

Return to “Wiring and Sensors”