MSefi.com read only forum (Jan.15,2018)

hello,

I need help i am running a registered version of TS trying to configure an MSII efi v3.57 with code rev. 2.905.

I am trying to open basic tables and every single one is greyed out and unmodifiable. I have reloaded TS a couple times.
i have tried running TSlite on another laptop and have been able to get at the VE, afr, and spark tables.

additionally i cannot locate the VE generator and i am unsure if i have set base settings for the ignition correctly. i am trying to implement ms on a 1989 honda civic with the stock distributor.

any help is greatly appreciated, i am getting super frustrated searching for answers. i have attached my current msq.

Thanks,
Juan

What version of TS are we talking here?

Ken

I have the latest version of tunerstudio running on a laptop running windows xp tablet edition.

TS v1.007

This is a common problem.

With MSII B&G firmware, there is a Project setting for MAPBaro and a firmware setting for MAP Baro, if 1 is on the other must be too or your tables will be disabled.

Check the setting:
"Fuel Set-Up" --> "Other Fuel Settings" --> "VE/SPK/AFR table index"

and in the Project Properties (Press CTRL+P), click the Settings tab
Check the "MAP Baro" Setting.

You need to make sure they are either both set to MAP Baro, or both not set to MAP Baro.