Page 1 of 1
Help with voltage
Posted: Tue Apr 17, 2012 2:20 pm
by Richiep
I'm building my ms2 v3.0 , I'm at step 23 but I can't get any voltage on pin 31 but i can on the rest, also do I need to install the jumpers on step 22 if I'm using a Pwm idle valve in step 62 , any help would be grateful .
Re: Help with voltage
Posted: Thu Apr 19, 2012 4:54 am
by Matt Cramer
The jumpers are optional; we usually put them in later in the build process.
I'd check for a cold solder joint.
Re: Help with voltage
Posted: Thu Apr 19, 2012 8:40 am
by Richiep
Sorted voltage problem but do I still install the jumpers in step 22 for steeper valve if I'm using a Pwm valve ???
Re: Help with voltage
Posted: Tue Apr 24, 2012 5:42 am
by Matt Cramer
The jumpers are optional; we usually put them in later in the build process. They're useful as general purpose inputs and outputs.