MSefi.com read only forum (Jan.15,2018)

I'm gathering some info before my build and my question is will this:
http://www.DIYAutoTune.com/catalog/64-p ... p-506.html
connect to the V3 board and fit inside the case in this:
http://www.DIYAutoTune.com/catalog/mega ... p-108.html

Obviously, I would have to cut a hole...but is there enough room to accommodate the connector? I've searched around but couldn't fine the answer I was looking for.

Thanks,
Don

It would need some jumper wires to connect it and you'd probably end up with the connector somehow attached to the lid, but I've seen similar things done.