MSefi.com read only forum (Jan.15,2018)

I just purchased one of the MS2 PCB v3.0 ECU kits and I'm a bit confused on how to assemble it for a 1997 Eagle Talon 2.0L NT application. I will be adding a turbo on this engine later. I also have a MSD DIS4 ignition installed. So basically my question is, what jumpers do I need to use and what components on the board should I omit?? Any help or input would be greatly appreciated.

Thanks,
Tony Woodside

If you are using standard Bowling & Grippo code, you will need to do an EDIS conversion. See this link:

http://www.megamanual.com/ms2/EDIS.htm

If you want to use the stock trigger wheel, you will need MS2/Extra, which is covered at MSExtra.com.