injector resistor

For discussing injector selection,manifold modifications, throttle bodies, fuel supply system design and construction, and FIdle valves and IACs.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
355vette
Helpful Squirter
Posts: 72
Joined: Fri Aug 24, 2007 9:06 pm
Location: Vancouer Island

injector resistor

Post by 355vette »

My MS has been running on the run stand and am now going to put it on my suburban which has tbi. I want to leave the gm computer operational so that I can switch it back to stock when I am happy the MS is set up right. I will put it on my hotrod and put the burb back to stock. My plan is to use a 4 ohm resistor on the gm wires which should make the gm ecm think it is doing its job. My question is what wattage should I use for the 4 ohm. You can probably tell I am not an electronics guy, I just follow the directions.
Top
Bernard Fife
Master Squirter
Posts: 475
Joined: Thu Oct 29, 2009 12:54 pm

Re: injector resistor

Post by Bernard Fife »

355Vette,

See this: http://www.megamanual.com/v22manual/minj.htm#injresist

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Top
Post Reply

Return to “Injectors, Fuel & Air Supply”