MSefi.com read only forum (Jan.15,2018)

ok i have a ms2 v 3
setup goes as follows
1.5l 12v engine turbo hyundai
500cc inj
walbro 255
fpr

ok i just got evrything in running fuel only
i got it to run and idle kinda shitty now im trying to adjust stuff on the ve table but im lost
any one give me a hand maybee some sort of base map ?

and heres the msq

1. It's idling too lean. Add more fuel at idle.

2. You are losing the RPM signal above 2000 RPM. If you are using a VR sensor, see this article on how to adjust the trim pots:

http://www.DIYAutoTune.com/tech_article ... _index.htm

thanks matt that whas what i needed to see

but theres 2 fixes

whitch should i start with

adjusting the pot with a o scope or placing a resistor inline with the cks