MSefi.com read only forum (Jan.15,2018)

Hi people!
I have very big problem first of all sorry for my bad english!
Lets start!!
I make instalation on my vw mk2 2.0 16v
All wirring are connect by sheme of msq
I i connect all sensors & i am sure its ok couse i done this job of wirring before!
Problem is couse i use mitchu coil but i put map of 16vt with o.e.m coil.
Problem now is on my msq ecu all led lights now lightning constantly
With key contact & when i starting engine!!
What happend now my ecu & coil heating & led lihts on ecu lightning all time.
I take cover of my ecu try to figure maybe something is melted but everytuing is in nice shape i didnt note something.
What happend did bad map destroy my ecu or i need something to change in parametars.
Please help!!

Are there any problems besides all LEDs being on? Or are there other problems?

My coil heat &ecu during using megatun 2.25 p3 program!!
&all leds light are turnd on!!!
It was everything ok until i burnd wrong map in ecu!!
In that map coil are diffrent as i have on!
My coil its from mitchubishi @in that map are not same coil what i have!!
I think parametars are difrent for coil & supply!!

Ok, what sort of circuit are you using to drive the coil?