MSefi.com read only forum (Jan.15,2018)

Hi Folks,

Ive just put together an MS2 for a freind on a V3 board, just got to the stage where Ive stuffed the code into it (2.905) and testing it on the stim...

with no RPM I'm getting a Pulse Width reading which seems a bit odd, it does not alter with any pot changes except if I change the coolant temp and then cycle the power, also I can try it with an RPM reading at the moment as my stim is playing up.

Its been a while since Ive looked at MS, and this is the first MS2 set up Ive done (normally run MS2extra) is this normal behaviour related to ASE or warmup ect, or does it sound squiffy?

I should add Ive reblown the code a couple of times now and am seeing the same thing.

Thanks,

Joe

JC,

You need to have an RPM signal to see changes in the pulse width.

Lance.

Ok Fair enough,

But shouldnt the PW still drop to 0 with no rpm? or does it show the last value.