MSefi.com read only forum (Jan.15,2018)

Hey so I got my ms2 v3 board aysembled, and the harness together on my 78 280z. using the stock l28e, and tring to start it with fuel control only. i am getting a rpm signal in tunner studio from the - coil. it shows the pulse in tunerstudios, but is reading 21-22 afr from my lc1. the injector led is not flashing, and also nothing at the injectors them self. i dont know were to go next. uploaded a data log

Test the MS2 on a Stim; do the injector LEDs pulse on a Stim?

It was the extra flux that I didn't clean off. sorry, also noticed that I had set it for microsquirt and not ms2.