Hey guys,
I have a MS2 ECU V2.90 with a MSD6a set up wired per the manual and it works. However, I want to shut off ignition control (control fuel only) and can not figure out how to do it. I am using Tuner Studio MS (Beta) v2.213. I have spent a lot of time looking through the settings and can not seem to find it. Thank you for your help. Kirk
Shutting off ignition control?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
savage2506
- MegaSquirt Newbie
- Posts: 14
- Joined: Fri Sep 16, 2011 5:28 pm
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: Shutting off ignition control?
s2506,
There is no software shut-off for the ignition control. Instead, simply don't connect the ignition output signal on pin #36 of the DB37 connector (don't ground it, just tape it up so it doesn't touch anything). Then ignore any of the ignition output settings (like the spark advance table, etc.). It is that simple.
Lance.
There is no software shut-off for the ignition control. Instead, simply don't connect the ignition output signal on pin #36 of the DB37 connector (don't ground it, just tape it up so it doesn't touch anything). Then ignore any of the ignition output settings (like the spark advance table, etc.). It is that simple.
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
-
savage2506
- MegaSquirt Newbie
- Posts: 14
- Joined: Fri Sep 16, 2011 5:28 pm
Re: Shutting off ignition control?
Thank you Lance.