MSefi.com read only forum (Jan.15,2018)

Posted: **Wed Aug 28, 2013 1:56 pm**

I have read the info under the products. Has anyone done this and what was the outcome? I built the board and can go back in and add to it. It says I need to add pull up resistors. is that all that is needed? do I ditch the ford EDIS module and fire off of the board then?

Posted: **Thu Aug 29, 2013 6:42 am**

Direct control of a distributorless ignition requires MS2/Extra, covered at MSExtra.com.

MSefi.com read only forum (Jan.15,2018)

MSII 3.0 changes needed for IGN-1A coils

MSII 3.0 changes needed for IGN-1A coils

Re: MSII 3.0 changes needed for IGN-1A coils