Need help with instructions......

[tanthius]

I'm building a ms2 v3.0 and its going on gm motors so im readin instructions and at i hit this.

22. Now you need to make a decision on the first 'optional' component: if you are going to use an IAC stepper motor with MegaSquirt-II, you must install a jumper from the hole marked S12C to the hole marked JS9 (+12C). These are on the bottom side of the board, on the DB9 side of the processor. DO NOT INSTALL THIS JUMPER FOR NON-MegaSquirt-II APPLICATIONS - IT WILL DESTROY THE PROCESSOR!!

If you are going to use a stepper style IAC (such as the GM IAC), you need to connect jumpers to bring the controller signals out to the DB37:

Connect (1A)JS0 (under the processor socket) to IAC1A (near the DB37 connector) - this brings out IAC1A on DB37 pin #25
Connect (1B)JS1 (under the processor socket) to IAC1B (near the DB37 connector) - this brings out IAC1B on DB37 pin #27
Connect (2A)JS2 (under the processor socket) to IAC2A (near the DB37 connector) - this brings out IAC2A on DB37 pin #29
Connect (2B)JS3 (under the processor socket) to IAC2B (near the DB37 connector) - this brings out IAC2B on DB37 pin #31
If you will be using an ignition output signal to control a coil or ignition module with MS-II, you will, likely be directed to jumper JS10 to:

question is does this mean i make a small wire from js0 to iac1a on bottom side of board cause iac1a on to of board is under the socket for the main chip. jumpers are not supplied in kit so im assuming you connect them. its a noob question but i wanna be right before i jump in i keep searching and getting nothing. a more indepth explanation would help.

[Matt Cramer]

Yes, you use a length of ordinary wire.

[tanthius]

yeah im a fool after searching picture instead of article i found out what i needed. thanks for the reply though