Page 1 of 1
EDIS crank sensor question
Posted: Sat Mar 15, 2014 4:37 pm
by slow67
New to the board, This is my first experience with EDIS ignition and I have ran across a question. The EDIS crank sensor has a positive and a negative feed from the module. My question is looking at the connector which wire goes to positive? I haven't had much luck in finding an answer
Thanks!
Re: EDIS crank sensor question
Posted: Sat Mar 15, 2014 6:47 pm
by kjones6039
slow67 wrote:The EDIS crank sensor has a positive and a negative feed from the module.
Just for clarification, the leads from the sensor to the EDIS module are
not simply
positive or
negative! One of the wires is actually an a/c
signal (often marked +) from the sensor and the other one is grounded back to the module.
In my experience there is no canned answer as to the pinout for these sensors. Which particular Ford sensor are you using?
Ken
Re: EDIS crank sensor question
Posted: Sun Mar 16, 2014 1:22 am
by trakkies
Go to this site:-
http://trigger-wheels.com/store/contents/en-uk/d10.html
Click on the pic of their sensor and you'll see the connections for that.
The other answer is if it doesn't work try reversing them.
Re: EDIS crank sensor question
Posted: Sun Jul 20, 2014 7:26 pm
by hemilove
+1 I also did this