VR sensor outputs about the same? Need to select 4 geomtry

[skikir]

I'm adding EDIS-6 to my 72 TR6. I need to select a VR sensor. I'm using parts from a 91 Ranger 6 cylinder (Because that is what I found first in the junk yard) I need to design a VR sensor mounting bracket to fit the the engine since it never had one. The sensor geometry for the ranger was totally not usable so I have to come up with something else. I cruised the NAPA web site and found scads of VR sensors that look like what I want to use. The question is, Electronically speaking, do they have same output that will work with the EDIS-6 module? Should I stay close to the the year of the EDIS and is 4 and 8 the same as 6 cylinder outputs. Logically, I would think they would be the same but I try never to assume anything. I'm looking for as small sensor as possible with a single mounting bolt hole parallel with sensor body. I have an idea of how I'm going to do this but really need a sensor in hand to fit it. I don't know at this point weather I need a straight, 45 or 90 degree connector.

Thanks.

[DonTZ125]

A VR sensor is a VR sensor. There may be differences in temperature ratings or the like, but the signal shape will be the same.

[kjones6039]

In addition to Don's advice,keep in mind that the placement of the sensor in relation to the crank wheel is critical when using EDIS! IIRC, tooth #6 for EDIS6....

Ken