MSefi.com read only forum (Jan.15,2018)

Hello,

I'm wondering how to setup and/or test the OEM coilpack of a VW VR6 2.9 12V from around 1995.
The Bosch number is 0 986 221 015

I am using TunerStudio 2.5.05
V3 Main with MSII chip
My Firmware is 2.92 Embedded Code By B&G.

Now it is not possible to test it (Only injector testing)?? Or how do I test this coilpack? Before (with other firmware and with MegaTune) I could test everything.

Something else, In my last setup, I had the coilpack connected through the OEM ignitionmodule that is attached to the coilpack, now I took that ignitionmodule off and connected it directly on the coilpack. Is that right? I did this because I red about some problems you could get with it in this topic:

http://msruns.com/viewtopic.php?f=88&t= ... ch#p142769
(The 4th reaction)

Can anyone help me further?

Greets Geert-Jan

I already found out that I used the wrong firmware.....

Preferred Code:
For those requiring a single spark output signal, such as for a distributors or crank wheels (but no cam signal and a single coil), version 2.920 is the preferred choice of codes....

Now I still want to know the following:

In my last setup, I had the coilpack connected through the OEM ignitionmodule that is attached to the coilpack, now I took that ignitionmodule off and connected it directly on the coilpack. Is that right? I did this because I red about some problems you could get with it in this topic:

http://msruns.com/viewtopic.php?f=88&t= ... ch#p142769
(The 4th reaction)


Are there no modifications needed to my MS board?