Page 1 of 1
RPM Reading inacuate
Posted: Mon Jun 02, 2014 4:41 pm
by skip406
Hi i am using MS-II V-3.0 on a buggy with a suzuki swift gt 1994 1.3 liter dohc supercharged, it started up fine but the RPM is reading two to three
time's what it actually is,any help would be great.
ps im a newby and i cant type.
Re: RPM Reading inacuate
Posted: Tue Jun 03, 2014 4:23 am
by Matt Cramer
Can you post a copy of your MSQ?
What exactly are you using for RPM input?
Re: RPM Reading inacuate
Posted: Wed Jun 04, 2014 6:01 pm
by skip406
Sorry about the lack of info. I am running MS-II 3.0 with v 2.92 firmware with suzuki swift dist, direct coil controll, conected as the manual says,coil + to 12volt off fuel pump relay
coil - to ign output #36, using vr in dist wired to pin#2 and #25. And im not sure how to get my msq over to here.
Re: RPM Reading inacuate
Posted: Wed Jun 04, 2014 7:49 pm
by kjones6039
skip406 wrote:And im not sure how to get my msq over to here.
In the Reply window, click on the
Upload attachment tab and browse for your msq file.
Ken
Re: RPM Reading inacuate
Posted: Thu Jun 05, 2014 3:45 pm
by skip406
PART_1371696767967.jpeg
I hope this is what is needed, I included a pic of the dist
Re: RPM Reading inacuate
Posted: Thu Jun 05, 2014 4:12 pm
by skip406
I hope this msq helps any info would be great thanks mat.
Re: RPM Reading inacuate
Posted: Fri Jun 06, 2014 5:12 am
by Matt Cramer
MS2 B&G code does not work with that pattern. You will have to either cut the wheel down to four equally spaced teeth, or use MS2/Extra code, which has a separate support forum on MSExtra.com.
Re: RPM Reading inacuate
Posted: Fri Jun 06, 2014 6:02 am
by skip406
thanks i figured i would have to cut down the reluctor.
Re: RPM Reading inacuate
Posted: Fri Jun 06, 2014 6:52 pm
by skip406
Matt thanks for the info i cut off eight of the reluctor points and it runs great!!