Page 1 of 1
Second map sensor placement
Posted: Tue Oct 21, 2014 8:35 pm
by h82crash
Does anyone have a pic of the independant baro sensor installation. Just would like to get ideas on how others mounted it. Was thinking double sided foam tape to the back of the main board. Is this ok? Thanks.
Tom
Re: Second map sensor placement
Posted: Thu Oct 30, 2014 6:54 pm
by h82crash
Thanks for the help. It is a V3.0 board MS2 running 2.920 firmware. I cut the pins on the sensor and soldered short leads to the necessary points. I then used 3M VHB double sided mounting tape and placed it on the back side of the proto area. Seems very secure and shouldn't see any heat to affect the adhesive.
