MSefi.com read only forum (Jan.15,2018)

hello new to this site.I have been doing some research here and the info.is a little overwhelming so I thought I would just ask. I have mega squirt 2 that I'm using on a 6-71 blown big block chevy . I'm using a enderle bug catcher to control the air. my question is what kind and size injectors should I use to make it easy on my self ?

thanks blowncoupe

What's your target horsepower, and how many injectors can you fit?

target horsepower is about 600 and I'll use 8 injectors

thanks blowncoupe

blowncoupe,

Did you see this: http://www.megamanual.com/v22manual/minj.htm#size

It gives 44.1 pounds per hour as the minimum required flow rate for 600HP and 8 injectors. There is lots more info about injector selection there too.

Steven

Ya I seen that steven. I'm more concerned about what kind works best with MS. high or low impedance or what brand works better original GM, Bosh or is there a after market brand that works better

thanks Blowncoupe





,.

High impedance is a lot easier to set up; they put out a lot less electrical noise.