Tps reading 0
Posted: Wed Apr 06, 2016 8:32 pm
Hey guys. I just wired in a veritable tps. But this problem isn't new to the brand new tps.
No matter the voltage going to the megasquirt (at the factory loom) the calibration always reads 0. Atm I am just running with the reading. I would really like to use this new variable tps. Any ideas?
Should I run it through the input pins or is factory harness input okay?
Jacob
No matter the voltage going to the megasquirt (at the factory loom) the calibration always reads 0. Atm I am just running with the reading. I would really like to use this new variable tps. Any ideas?
Should I run it through the input pins or is factory harness input okay?
Jacob