Page 1 of 1
error loading firmware
Posted: Wed Oct 25, 2017 8:58 pm
by wisemanbuilds
ms2 trying to load firmware it seems to load and then when verifying it runs into various errors is there anybody who has ran into this problem and worked through it. every thread I read that has similar problems just dead ends with no solutions... please help
Re: error loading firmware
Posted: Thu Oct 26, 2017 5:10 am
by Matt Cramer
Please post a screen shot of the messages you got. There may be important clues in their exact wording.
Re: error loading firmware
Posted: Thu Oct 26, 2017 5:13 am
by trakkies
One thing I discovered is it needs a decent power supply. Seems to need more current to load code than simply running with a Stim on test. Just something to check. Other thing is I always use the old desktop with proper serial port. Takes one more thing like the USB adaptor out of the equation.
Re: error loading firmware
Posted: Tue Nov 21, 2017 1:06 pm
by Matt Cramer
trakkies wrote: Thu Oct 26, 2017 5:13 am
One thing I discovered is it needs a decent power supply. Seems to need more current to load code than simply running with a Stim on test. Just something to check. Other thing is I always use the old desktop with proper serial port. Takes one more thing like the USB adaptor out of the equation.
Very true. 9 volt batteries sometimes run out of power before they can load firmware.
Re: error loading firmware
Posted: Tue Nov 21, 2017 3:14 pm
by kjones6039
Agreed. I have never had a problem with the stim though.
Ken