Page 1 of 1
MAP Sensor Connector Size?
Posted: Sun Jun 26, 2005 10:42 am
by gboone
I'm making a MAP manifold to connect to my intake manifold and want to make it the same size as the MAP sensor on the MS box. I've not yet chosen which system I'll use but I found that all the MS systems use the same MAP sensor. But I can't find any info on the connector size and type. Please help. TIA.
Posted: Sun Jun 26, 2005 10:56 am
by Jamesl
It's just a piece of fairly generic vacuum hose that runs from the MS MAP sensor to a vacuum port on your manifold. I think it's 1/8th inch. I was able to plug it into an existing vacuum port on my car.
Still no definiite answer after almost a year
Posted: Wed May 03, 2006 5:22 pm
by gboone
Does someone have a definite answer to my question? I'd prefer some degree of certainty rather than "I think it's ..."
Thanks