MSefi.com read only forum (Jan.15,2018)

Hello Roger,

I'd like to recompile a modded code (like mskpa.asm but #100T as refernce instead of #65T --> allways open loop (n/a) viewtopic.php?t=1233). Lance was so kind to compile it for me, but I use BOSCH and DENSO sensors.

Is it necessary to use the P&E stuff or is it possible t do with ET4?
Can I start select 'custom', select mskpa.s19 with Start Adress "F500" (like code 2.98/3.0)? I ask because 65T has only 2 but 100T has 3 digits and I can't test correct math with stim. Sorry if this sounds stupid but I know only that's possible to make errors, but not how (how not).

»Horst

ami8break wrote:Hello Roger,

I'd like to recompile a modded code (like mskpa.asm but #100T as refernce instead of #65T --> allways open loop (n/a) viewtopic.php?t=1233). Lance was so kind to compile it for me, but I use BOSCH and DENSO sensors.

Is it necessary to use the P&E stuff or is it possible t do with ET4?
Can I start select 'custom', select mskpa.s19 with Start Adress "F500" (like code 2.98/3.0)? I ask because 65T has only 2 but 100T has 3 digits and I can't test correct math with stim. Sorry if this sounds "slow" but I know only that's possible to make errors, but not how (how not).

»Horst

Horst,

Yes, you can use EasyTherm for this purpose. Select custom, F500, hit 'Create', browse to your .s19 file. ET will create a new .s19 file with 'mod' in the name (ie meganew.s19 -> meganewmod.s19). When you hit download' it grabs the mod version , and downloads to MS.

Roger.

Hello Roger,

thank you. ET4 and start adress F500 worked perfect, but I was dissapointed about Steinhart-Hart approximation. More: viewtopic.php?t=2421

»Horst