Alright,
I dataloged a 20 min drive and had megalogviewer do its magic. Attached is my msq with the new VE table from megalogviewer. It looks funny to me so I was hoping that someone could glance over it before I try to run the motor on this VE table.
Thanks all,
Search found 4 matches
- Fri Aug 05, 2011 4:33 pm
- Forum: Tuning Fuel and Air
- Topic: Trouble setting up a good VE table
- Replies: 5
- Views: 553
- Tue Aug 02, 2011 8:03 am
- Forum: Tuning Fuel and Air
- Topic: Trouble setting up a good VE table
- Replies: 5
- Views: 553
Re: Trouble setting up a good VE table
my setup on 383 SBC with similar injectors and cam my idle looks just a bit more rich and all the way up rich over 50%, launch datalog, drive for about 20 mins with low and mid RPM, then do analyze with MegaLogViewer and that should help you, this is easest way to get drivable map, is it narrow or ...
- Tue Aug 02, 2011 4:15 am
- Forum: Tuning Fuel and Air
- Topic: Trouble setting up a good VE table
- Replies: 5
- Views: 553
Re: Trouble setting up a good VE table
Also, forgot to mention that I am running EDIS8 for ignition.
Thank you,
Thank you,
- Mon Aug 01, 2011 7:13 pm
- Forum: Tuning Fuel and Air
- Topic: Trouble setting up a good VE table
- Replies: 5
- Views: 553
Trouble setting up a good VE table
Hello all,
I installed megasquirt 2 years ago and got it running, but not well. I finally have the time to work on my car and I want this to work.
As far as I can tell I need to set up my VE table better to keep from running very lean. Can anyone please help.
I am currently running:
350 motor 8.5 ...
I installed megasquirt 2 years ago and got it running, but not well. I finally have the time to work on my car and I want this to work.
As far as I can tell I need to set up my VE table better to keep from running very lean. Can anyone please help.
I am currently running:
350 motor 8.5 ...