Search found 3 matches

by jeremy k
Sat Mar 19, 2011 6:50 pm
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Looking for EDIS8 VR sensor bracket ideas
Replies: 8
Views: 673

Re: Looking for EDIS8 VR sensor bracket ideas

Mount the trigger in an accessible spot for replacement (not likely) & make sure you use shielded trigger wire cable thta ties into the module's and ms input shield's .. make's for a noise free ignition , and the coil condenser ! , don't forget that

otherwise rock on , I'm running my 2.5 dodge on ...
by jeremy k
Mon Mar 07, 2011 4:19 am
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: coil that can be used with edis
Replies: 2
Views: 334

Re: coil that can be used with edis

if the crank trigger is a 36-1 go with the edis module and tie 1/4 & 2/3 together for the module's output ! instant Waste spark COP ! I run my dodge 2.0 dohc coil with an edis4 module , haven't experienced any troubles so far !!
by jeremy k
Sat Jan 22, 2011 8:26 pm
Forum: General Information
Topic: MS for a Saturn Dirt Car
Replies: 4
Views: 457

Re: MS for a Saturn Dirt Car

short , Yes.