Simple question, on MS2 v3, I currently have my Fidle solenoid wired using the FIDLE output as ground activation to my relay. I would like to give my PWM idle valve a shot, so I just want to confirm that I will bypass the relay, use the same FIDLE output as ground directly to the valve and the other pin of the valve will be 12V?
Again, sorry but I couldn't find this info clearly on the assembly or tuning manual. Thanks!
wiring of PWM idle valve
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
wiring of PWM idle valve
1990 Audi 200 Turbo Quattro @ 18psi
powered by: MSII v.3 + dash mounted MegaView
powered by: MSII v.3 + dash mounted MegaView
-
FixItAgainTony
- Helpful Squirter
- Posts: 82
- Joined: Thu Feb 03, 2005 1:09 pm
richiea,
What you are looking for is probably at the end of this link:
http://www.megamanual.com/ms2/IAC.htm#fidle
Do not forget to put the diode across the idle valve wires. This is for flyback protection.
Charles.
What you are looking for is probably at the end of this link:
http://www.megamanual.com/ms2/IAC.htm#fidle
Do not forget to put the diode across the idle valve wires. This is for flyback protection.
Charles.
Fiat - A great car for those who like to walk.