Alan
Change to high resistance injectors???
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Change to high resistance injectors???
I picked up a set of 40lb injectors for my 2.3 turbo. I am currently running the stock low z 35's. The new ones are 40 high z. My MS2, v3.0 has the flyback and pwm installed for the low ones. Can I change to the new ones without any mods other than programming? In reading the manual it looks ok, but I want another opinion. Thanks for the help!!
Alan
Alan
Rangerman
arritter@sbcglobal.net
arritter@sbcglobal.net
-
rabiddeity
- MegaSquirt Newbie
- Posts: 5
- Joined: Tue Mar 13, 2007 9:28 pm
- Location: back in the USA
Yep, you're good to go. Just set the PWM duty cycle and such, straight from the manual, and then get your REQ_FUEL straightened out. It's not as dangerous to change from low-Z to high-Z injectors, because even if you leave everything the same it won't burn out the injectors (it'll just start and then die immediately).