MS-II v2.686
MegaTune v2.25
MegaLogViewer v2.73
Hey folks,
I have my AE RPM scaling set with:
Low Thresh = 2000rpm
High Thread = 2600rpm
I wanted to see what happens when I have AE for just for off-idle enrichment. However, I just looked at a datalog it's flagging Accel:Y at 4300rpm+
I thought that "High Thresh" is the point where any AE is turned off? And "Low Thresh" is the point where AE goes from full on, to linearly diminishing up to the high thresh zero point.
Is there something to set to turn the scaling "on"? Or is something odd happening?
AE RPM Scaling - Not Working?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
AE RPM Scaling - Not Working?
1980 924TurboS
MS-II, v2.872, EDIS
MS-II, v2.872, EDIS
I looked at the code and the ae scaler should cut off all AE after the hi rpm (it sets tpsaccel = 0 if rpm > hi_rpm_threshold). Its pretty straightforward. However, if your datalog shows a non-zero tpsaccel on the same line with an rpm > threshhold, then I would like to see that. You shouldn't have to do anything to activate the cutoff other than setting the lo and hi rpms.
A-ha! I didn't know this was based on TPSdot only. I was running 100% MAPdot. I'll make the switch to TPS AE (been meaning to anyway).grippo wrote:I looked at the code and the ae scaler should cut off all AE after the hi rpm (it sets tpsaccel = 0 if rpm > hi_rpm_threshold).
Thanks for the quick answer
nick
1980 924TurboS
MS-II, v2.872, EDIS
MS-II, v2.872, EDIS