Factory Sensor/MSll wiring

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Ego Killer
MegaSquirt Newbie
Posts: 3
Joined: Thu Nov 22, 2007 8:54 pm
Location: WPB,FL

Factory Sensor/MSll wiring

Post by Ego Killer »

i have a MSll and got the wiring harness along with air temp and coolent temp sensor for the MSll with a 3.0 board and i am installing it on a 2000 Turbo Crown Vic. i am keeping the factory EEC to run the gauges. if i make a new wiring harness for the injectors, coils, VR, edis, air temp, and coolent temp. can i piggie back the factory sensor wires(VR,air temp,and coolent temp) for the gauges?
Top
Ego Killer
MegaSquirt Newbie
Posts: 3
Joined: Thu Nov 22, 2007 8:54 pm
Location: WPB,FL

Post by Ego Killer »

Thank you
Top
Post Reply

Return to “Wiring and Sensors”