hello.
I will begin to tune an engine for afr.I bought a o2 LC1 to diyoutune and have read the manual, I have more or less clear how to do it.
on the spark he also read, this engine has a knock three wires that goes straight home to the ecu, the manual says to put a knock GM with a driver, I have many doubts as to adjust the spark, and how to configure and install the knock, origin or when GM and know that this detonating the engine, someone can guide a bit?.
I have also seen a link of the handbook a module that connects with an outside MS2 led to see when the engine detonates, but as in MS2 detonates when it must be said (in my country we say sting), to know this must be done a DATALOG or something and see the peaks of pressure, and say when we feel that detonates.
of course without EGT, but I also read that with the warming of the O2 can I get an idea of the temperature of the exhaust, but will not be very accurate but can serve as guidance.
can you help me?, I am concerned about the pitch of the spark, thanks.
parameters knock sensor
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
valenciano
- Helpful Squirter
- Posts: 43
- Joined: Fri Sep 05, 2008 12:44 pm
Re: parameters knock sensor
Nobody can orientate me with the sensor of detonation.
And well-read on snocksense, but I have doubts:
- to install with my sensor of detonation, valeo 2 cables.
- the page of snocksense says that a led is ignited when there is detonation, but it is with all the sensors and cylinder capacities equally.
If someone it to used you can say to me since it works thank you.
And well-read on snocksense, but I have doubts:
- to install with my sensor of detonation, valeo 2 cables.
- the page of snocksense says that a led is ignited when there is detonation, but it is with all the sensors and cylinder capacities equally.
If someone it to used you can say to me since it works thank you.