Set up is supercharged EFI, can I place the O2 sensor in a single tube?? I know the the controller would tune the A/F ratio to
just that cylinder. However if air and fuel distribution are good all cylinders will have the same tune, correct?? This motor runs idle or WOT 3600 to 6000 rpm. I am long time racer but new to this board and to the EFI technology.
Zoomie Headers (no collector)
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Zoomie Headers (no collector)
That should work, though keep in mind you'll probably see a bit of reversion at the end of the pipe at low RPM.
Re: Zoomie Headers (no collector)
Thanks Matt
The project is still in the parts and pieces collection and design stages and I have three other cars to build this year. I'll keep the board posted and I'm sure have other question as it goes along.
Jim
The project is still in the parts and pieces collection and design stages and I have three other cars to build this year. I'll keep the board posted and I'm sure have other question as it goes along.
Jim