MS2-V3: Testing Ignition with Stim

patrickbrown · Post by **patrickbrown** » Thu Mar 19, 2009 6:57 am

I don't think my ignition is working. I have built with the hall and VR circuit. I have it jumpered to use hall circuit. I have the stim ver 2.21 with five lights. Yje IGN light stays lit regardless of RPM. Is this a software setting or did I miss something in the build?

I'm running 2.888 code.

Matt Cramer · Post by **Matt Cramer** » Thu Mar 19, 2009 11:11 am

If you change the Spark Output from Going Low to Going High or vice versa, does the LED go out?

patrickbrown · Post by **patrickbrown** » Thu Mar 19, 2009 1:43 pm

I had it set to "Going High (Inverted)" for EDIS support. I changed it to "Going Low (Normal)" and reset the MS. The IG LED blinks now and the rate follows the RPM knob. It seems to work. I change it back to Going High.

Thanks,

Matt Cramer · Post by **Matt Cramer** » Mon Mar 23, 2009 6:34 am

Sounds like all is working. Some settings just plain don't make the light blink in a way that's perceptible without an oscilloscope.

patrickbrown · Post by **patrickbrown** » Mon Mar 23, 2009 8:36 am

Thanks Matt.

MSefi.com read only forum (Jan.15,2018)

MS2-V3: Testing Ignition with Stim

MS2-V3: Testing Ignition with Stim

Re: MS2-V3: Testing Ignition with Stim

Re: MS2-V3: Testing Ignition with Stim

Re: MS2-V3: Testing Ignition with Stim

Re: MS2-V3: Testing Ignition with Stim