Bosch 4 Pin dual curve TPS

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
brett_qld
MegaSquirt Newbie
Posts: 1
Joined: Fri Dec 18, 2009 3:14 am

Bosch 4 Pin dual curve TPS

Post by brett_qld »

Hi this may have been covered elsewhere, I have not found it using the search function.

I have a Bosch Throttle Position Sensor, it is the 4 pin type with the 'dual curve' to provide greater resolution for the initial part of the throttle opening (first 23 degrees of rotation).
I intend to connect it to the Microsquirt controller. Is this possible?

The application is a turbocharged motorcycle, the tps is mounted to the throttlebody / injector unit, which makes very compact and easy bolt on conversion.

Info on TPS:
Bosch part# 0 280 122 201.

Thanks
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: Bosch 4 Pin dual curve TPS

Post by Matt Cramer »

You'd just use the wide range section; the code doesn't support more than one TPS without mods.
Top
Post Reply

Return to “Wiring and Sensors”