Hello everyone,
I have a MS2 ver 3.0 using 2.891 code, 36-1 crank sensor with VR pickup. I got into trouble as I was searching around the forum and found in the Extra section board mods and coil hookup for a set up that I wish to use. Being new to all this and trying to learn as much as I can on my own after posting a question I was told I can't mix with MS2. Now that I have everything modified for the two direct outputs for Extra can someone help me locate the process needed for MS2.
I have found and read the section on Microsquirt dual spark and see the M-N toothed wheel is possible for a 4 cly with one input and understand the setup in programming. I am not able to find the hookup for two coild and any mods required to do so. Could someone please help? Or since being new to all this what is required to use Extra code? Might be a silly question but never hurts to ask.
Thanks
Mark
Wasted Spark with Dual Coils Set Up Help
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Wasted Spark with Dual Coils Set Up Help
Go here. http://www.microsquirt.info/
Look in the left column for ignition and then dual spark. Gives a complete explanation of how to convert an MSll to dual spark.
Look in the left column for ignition and then dual spark. Gives a complete explanation of how to convert an MSll to dual spark.
Re: Wasted Spark with Dual Coils Set Up Help
Old Guy,
Thanks, that is the section I was reading and just not quit far enough yet. I will get it modified and should be ready to start it up.
Have a nice Easter!
Mark
Thanks, that is the section I was reading and just not quit far enough yet. I will get it modified and should be ready to start it up.
Have a nice Easter!
Mark
Re: Wasted Spark with Dual Coils Set Up Help
You can get dual spark with MS2, V3 and either regular or extra code. The regular code mod to get dual spark can be found at www.microsquirt.info, a little more than halfway down there is a section on Dual Spark and MS-II. If this is the same mod you made, then you can use either code. If not you need to ask this on the extra forum.