injectors flow with no pulse
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
injectors flow with no pulse
hey guys, im finally putting ms in my car. got vr wheel set up nice, edis works beauty(put gas in cylinders,pull fp fuse, and it runs),but the engine was flooding badly with the fuel pump fuse in. so i took out the injectors and fuel rail for testing.when in test mode injectors pulse and it looks normal,when i try to start the car the injectors come on full blast with no pulsing. i checked the pulse width and % its 1.0 and 30.not sure what else to do? i have low imp. injectors 2.9ohm with a 385 cc /min flow @ 50 psi
-
msiddalingaiah
- Helpful Squirter
- Posts: 68
- Joined: Fri Oct 09, 2009 7:39 am
- Location: Maryland, US
- Contact:
Re: injectors flow with no pulse
Is there voltage across the injectors? The injector MOSFET might be stuck on for any number of reasons.
Madhu
1990 Suzuki DR350S EFI Conversion
Returnless, adjustable electronic Fuel Pump Controller requires less power
1990 Suzuki DR350S EFI Conversion
Returnless, adjustable electronic Fuel Pump Controller requires less power
Re: injectors flow with no pulse
otto went to the junk yard and found some hi imp. inj. and now the freekin car runs!!! ITS FINALLY TUNE TIME!!!!!!!