When using the KnockSense unit in conjunction with the MSII V3.0 code version 2.905 do I need to install the 1K resistor and Zenor diode and jumper IAC1B to JS4 OR just do the jumper?
Thanks
Scott
Knock Sense
-
ScottWerks
- MegaSquirt Newbie
- Posts: 3
- Joined: Tue Apr 05, 2005 8:52 am
- Location: Fort Worth TX
Knock Sense
MSII V3, 60-2 wheel, CHT, LC-1 WBO2, Knocksense, TwinPlug 3.4 911S
-
ScottWerks
- MegaSquirt Newbie
- Posts: 3
- Joined: Tue Apr 05, 2005 8:52 am
- Location: Fort Worth TX
Re: Knock Sense
Just FYI - It appears to work fine without the extra componets and just adding the jumper!
MSII V3, 60-2 wheel, CHT, LC-1 WBO2, Knocksense, TwinPlug 3.4 911S
-
DonTZ125
- Experienced Squirter
- Posts: 337
- Joined: Sat May 16, 2009 1:49 pm
- Location: Scarborough, ON
- Contact:
Re: Knock Sense
The reason for the extra parts is to protect the processor. If something happens to that signal wire and you wind up with +12v to that JS4 pin, you'll be buying a new MS2 card.
-
ScottWerks
- MegaSquirt Newbie
- Posts: 3
- Joined: Tue Apr 05, 2005 8:52 am
- Location: Fort Worth TX
Re: Knock Sense
Thanks Don! I have the parts so I'll put them in!
MSII V3, 60-2 wheel, CHT, LC-1 WBO2, Knocksense, TwinPlug 3.4 911S