MS-II daughter bd on V1.01 board.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
MS-II daughter bd on V1.01 board.
I purchased a blue MS-II daughter board in 2007 and couldn't get it to work thinking it was a problem with the trigger signal for the EDIS. It turned out to be dirty connectors in the EDIS system, but I had already re-installed the MS-1 processor with the pin bent up. I'm back trying to get the MS-II working for the idle control(can't stop the air from getting in through the throttle body IAC port). I know now the ignition on the car side works and I'm using tuner studio lite and have ver. 2.886 firmware. I believe all the settings are correct and I'm running into the same problem, my question is, will the MS-II work on the V1.01 board? -pj
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS-II daughter bd on V1.01 board.
It'll work on the V1.01 boards; it's just some of the extra outputs allowed by the MS2 are harder to install.
Re: MS-II daughter bd on V1.01 board.
That helps alot, do you know of a help or manual page or forum that address the V1.01 mods?
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS-II daughter bd on V1.01 board.
The schematics are a bit hard to find, but they're located here:
http://www.bgsoflex.com/v1/v1.html
No real mods guide, although you can use the V2.2 mods as a starting point.
http://www.bgsoflex.com/v1/v1.html
No real mods guide, although you can use the V2.2 mods as a starting point.