When i check the wiring diagramm for edis4, i can see that pin number 10 is connected to pin number 1 on the small connector and pin number 12 is connected to pin number 3 on the small connector. But when i remove the system out of the Ford car, the pin number 10 was connected to pin number 3 on the small connector and pin number 12 was connected to pin number 1 on the small connector. So the wires are switch. I test the system and i have sparks.
So what do i do... Switch them back or leave it like that?????
Thanks!!!!
John
EDIS4
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: EDIS4
Doesn't matter provided you swap the plug leads too. So either follow the MS diagram fully or the original Ford wiring. I found this too with EDIS8. If your coils are marked with the cylinder numbers, and you want to work to that, stay with the Ford wiring.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband