I just purchased one of the MS2 PCB v3.0 ECU kits and I'm a bit confused on how to assemble it for a 1997 Eagle Talon 2.0L NT application. I will be adding a turbo on this engine later. I also have a MSD DIS4 ignition installed. So basically my question is, what jumpers do I need to use and what components on the board should I omit?? Any help or input would be greatly appreciated.
Thanks,
Tony Woodside
MS2 PCB v3.0 assmbly help 420a
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
TonyWoodside
- MegaSquirt Newbie
- Posts: 1
- Joined: Thu Jun 21, 2012 10:56 am
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS2 PCB v3.0 assmbly help 420a
If you are using standard Bowling & Grippo code, you will need to do an EDIS conversion. See this link:
http://www.megamanual.com/ms2/EDIS.htm
If you want to use the stock trigger wheel, you will need MS2/Extra, which is covered at MSExtra.com.
http://www.megamanual.com/ms2/EDIS.htm
If you want to use the stock trigger wheel, you will need MS2/Extra, which is covered at MSExtra.com.
