DIYAutoTune has (2) Hall sensors available which seem to be used with steel trigger wheels. Does anyone know the width (not thickness) of the teeth that these sensors can be used with. Is there a width range? The wheels shown are square and pointed tooth wheels. Also they seem to be used as VR sensors. Is this because there are no magnets in the wheel?
Thanks for any help.
Hall sensors
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Hall sensors
1970 Honda N600 600cc Twin
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Hall sensors
The sensor has a 2-2-2 rule for the recommended minimum. 2 mm trigger wheel thickness, teeth must be at least 2 mm wide, the gaps must be at least 2 mm deep.
Re: Hall sensors
The trigger wheel I have is 4" in diameter with 35 teeth and 1 missing tooth. It is 1/8" thick steel. the teeth are 0.158 wide and the gap is 0.158 wide and 0.188 deep. Will this work with either of your sensors?
1970 Honda N600 600cc Twin
Re: Hall sensors
1/8" is 3.2mm 0.158 is 4mm 0.188" is 4.8mm. Near enough. So you are well within tolerance.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband