cam sensor question
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Porsche650
- MegaSquirt Newbie
- Posts: 12
- Joined: Tue Mar 05, 2013 6:52 pm
cam sensor question
I have a MS2 3.0 i was going to use with a ford edis system. Due to placement of the crank sensor and since i can put the distributor low on the block i was wondering if i could use just the distributor sensor with the ford edis system. At the system at the moment is a fiat distributor with electronic pickup, gm module, and bosch blue coil. What would be my best bet?
-
DonTZ125
- Experienced Squirter
- Posts: 337
- Joined: Sat May 16, 2009 1:49 pm
- Location: Scarborough, ON
- Contact:
Re: cam sensor question
EDIS can only be used with a 36-1 crank wheel; it's hard-coded into the EDIS module itself. You can use the distributor pickup as your main sensor, using a 'Basic Trigger' configuration.
