Different resistor values in VR circuit V3.0

[yaygasm]

Hi everybody, newbie here, just trying to troubleshoot a non functioning VR circuit. I've noticed that some of the resistor values listed here http://www.megamanual.com/ms2/vradjust.htm in this picture...

...are different than listed in the assembly guide (http://www.megamanual.com/ms2/V3assemble.htm). Specifically,
- R44/R45/R46/R54 are 1k in the schematic, 10k in the assembly guide
- R53/R48 are 100k in the schematic, 10k in the assembly guide

Just wondering if there's anybody out there that can shed some insight on this.

[Bernard Fife]

y,

You might want to read the notes below the same diagram here: http://www.megamanual.com/ms2/pcb.htm

Lance.

[trakkies]

Dunno why that schematic hasn't been altered. All the V3 boards (that I've seen) for many a year are supplied with the later values.

[yaygasm]

You might want to read the notes below the same diagram here: http://www.megamanual.com/ms2/pcb.htm

Thanks, there's a lot of good information on that page.

Dunno why that schematic hasn't been altered. All the V3 boards (that I've seen) for many a year are supplied with the later values.

Okay, if that's the case I guess I'll look for problems elsewhere, thanks.