MegaLogViewer updates summary...

[LT401Vette]

For the past week and a half there have been a lot of MLV releases, all of which have gone to autoupdate. How do you know if you really need them?

To Summarize....
If you are simply viewing log files there have been several cool features added since 2.0:
-MSQ load/edit - MS1/MSII/extra supporting MegaTune 2.25 msq files
-Table display -
-Table Editing, scale, increment, decrement, add, subtract copy/paste
-Cell weighted value displayed for each log record
-Jump to Min or max (Right click on graph)
-Jump to Mark
-Search for Field Value
-Hold Cursor centered
-Volt based afrTables As of 2.37
-Selectable Analysis AFR tables As of 2.37
-Avanced settings in VE Analysis As of 2.39

If you are using VE Analysis:
There have been several major improvements to the overall calculations right up to the current version 2.37

So, if you are just viewing log files there are many new and handy features, but if you are doing ve table tuning I REALLY recommend upgrading to the latest version.

Also ther have been changes to Auto update as of 2.30. This was not completing successfully for a few machines, but as of 2.30 I have not had any reports of failure. As of version 2.35 there is a progress bar for autoupdate to tell you how many bytes have been downloaded and remain....

[LT401Vette]

Lance, I've said it before and I'll say it again...
This site you host is the Megasquirt glue....

and I know what it takes maintain a site. fending off morons and such like you have had over the past couple weeks.

[LT401Vette]

Note as of version 2.35 AFR tables in volts are still not supported. for VE Analyze.

[LT401Vette]

As of version 2.37 Volt AFR tables are supported, You must select the right WB O2 sensor from the menu though.

However, if you edit an afrTable based on Volts, the changes will not be saved when you save the msq.