EDIS4 setting in Megatune

This forum is for discussing ignition setup, tuning, and troubleshooting for MS-II. Click these links for info on GM's HEI, EDIS, direct coil control, others.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
pit_celica
MegaSquirt Newbie
Posts: 24
Joined: Tue Jul 18, 2006 2:12 pm

EDIS4 setting in Megatune

Post by pit_celica »

Hi, I see in megatune that i need to set some settings for EDIS4 :

Trigger offset = 0°
Ignition Input Capture to 'Falling Edge'
Cranking Trigger to 'Calculated'
Coil Charging Scheme to 'EDIS',
Spark Output to 'Going High (Inverted)'
Set the predictor algorithm option to 'last interval'

I set thoses.

Do I need to set something else in the ignition setting?

Other question : When the middle LED on MSII is lighten up, what does it mean?

Here's a shot of my setting page.

Image

I'm using a MSII with V3.0 board.

I attached my .msq file to.

Thanks

Sam
Top
pit_celica
MegaSquirt Newbie
Posts: 24
Joined: Tue Jul 18, 2006 2:12 pm

Post by pit_celica »

yeah, I know this, but I want to know what values do I need to use in :
Next pulse tolerance : Cranking %, After start %, normal running %, predictor gain %, maximum spark duration? Do I need to set them to zero???

Thanks

Sam
Top
pit_celica
MegaSquirt Newbie
Posts: 24
Joined: Tue Jul 18, 2006 2:12 pm

Post by pit_celica »

i did a timing light test and I'm at 0° while cranking. I put 10° in trigger offset, but nothing changed. I look at my saw signal, and I have only a constant 35-40 milivolt while cranking??? I don't understand whats going on. If you know what can be my problem, plz post an answer.

Thanks

Sam
Top
Post Reply

Return to “MS-II Ignition Setup, Tuning, and Troubleshooting”