Hi,
I plane to use Ducati 996 TBI with dual Injector on a VW Flat4 engine.
The firing order is 1-4-3-2.
How i must wire the injector by pair/cylinder ?
Or like a V8 engine by cylinder bank?
Or Paired Inj ? (1-1 & 2-2 & 3-3 & 4-4)
They're low Impedance.
Thx
Patrick
Injector Wiring for 8 Inj and 4 Cylinder Engine
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
78Spit1500Fed
- MegaSquirt Newbie
- Posts: 33
- Joined: Thu Jul 29, 2004 4:36 am
- Location: Terre Haute, Indiana
- Contact:
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0) .
My gut says "bank" like injector set 1 on one bank, injector set 2 on the other... it depends entirely on how their purpose, however, and you're going to need some kind of dual table code.
-Brian
My gut says "bank" like injector set 1 on one bank, injector set 2 on the other... it depends entirely on how their purpose, however, and you're going to need some kind of dual table code.
-Brian
MegaSquirt License Plate Frames and Decals are available! PM me for more information!