I currently have my northstar running on a ford edis 8 setup, and well I want to try and get the coil on plug system working to get rid of the ugly spark plug wires. I tried searching these forums, but I find it a bit difficult to navigate. I did read someone had accomplished it using the edis system, but not much info was given on it. Can anyone help me out??
Thanks,
Phil
Northstar CoP
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
shadowplane676
- MegaSquirt Newbie
- Posts: 27
- Joined: Thu Oct 27, 2005 9:29 am
Re: Northstar CoP
you could wire 8 coils (in 4 pairs) to run a wasted spark Pseudo CoP setup. you'd still need to pair the coils to complimentary cylinders, but each coil would only be firing one cylinder. aside from the GPIO or sequencer, i dont think theres any provisions for CoP
1992 Plymouth Duster 5 speed
2001 mitsubishi 24v 6g72 3.0L v6
MS-II v3.0, MSII/Extra code, EDIS-6, LC-1 WBo2
2001 mitsubishi 24v 6g72 3.0L v6
MS-II v3.0, MSII/Extra code, EDIS-6, LC-1 WBo2
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Northstar CoP
Ford Mustang Cobra COP coils can work with an EDIS module if the coils are wired in series.
-
Philbur120
- MegaSquirt Newbie
- Posts: 2
- Joined: Sat Jun 07, 2008 12:40 pm
Re: Northstar CoP
hrmm ok, thanks for the replies. I need to do some thinkin!