Hello
I am using a MS 1V.3 PCB with the latest firmware. I am using Stimulator v.3.
I cannot read RPM signal unless i choose EDIS in the decoder field (and then fuel pump is controlled etc). If I choose Generic, in order to setup for my 60-2 wheel (the original one in my Peugeot TU 1.6 8V engine with Magneti Marelli 8P16 original ECU) there is no reading.
On the engine I also have no reading of RPM signal.
Any ideas?
Thanks
Kostas, Greece
No RPM signal
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: No RPM signal
Found it! When stimulator is connected, then for Generic wheel setting with teeth, the field in the Spark setting for trigger stim should be on, which should NEVER be left as it is when MS is connected to motor. It should return to off