MSefi.com read only forum (Jan.15,2018)

Hello
I am using a MS 1V.3 PCB with the latest firmware. I am using Stimulator v.3.
I cannot read RPM signal unless i choose EDIS in the decoder field (and then fuel pump is controlled etc). If I choose Generic, in order to setup for my 60-2 wheel (the original one in my Peugeot TU 1.6 8V engine with Magneti Marelli 8P16 original ECU) there is no reading.
On the engine I also have no reading of RPM signal.
Any ideas?

Thanks
Kostas, Greece

Found it! When stimulator is connected, then for Generic wheel setting with teeth, the field in the Spark setting for trigger stim should be on, which should NEVER be left as it is when MS is connected to motor. It should return to off